Simple Steps to Replace a Damaged Door Knob

Damaged Door Knob

A door knob, also known as a door handle, is a device that enables you to open and close a door. It is an essential component of any home or commercial property as it allows people to enter and exit a room or building easily. A damaged door knob can be frustrating and may even pose a security risk, particularly if it is on an exterior door. This article will outline the simple steps to replace a damaged door knob so that you can have a functional door once again.

Tools needed

Before beginning the project, you will need to gather the necessary tools. You will need a screwdriver, a replacement door knob, and screws. Depending on the type of door knob you have, you may also need a power drill. Make sure that you have all the required tools before beginning the project.

Removing the old door knob

To begin the replacement process, you must first remove the old door knob. To do so, you need to detach the knob from the latch. Look for a small hole on the side of the knob, insert a flathead screwdriver into the hole and push down to release the knob. You may need to use some force to detach the knob from the latch. Once the knob has been removed, you can then remove the screws from the faceplate. Keep the screws in a safe place, as you will need them later when installing the new door knob.

Installing the new door knob

The next step is to install the new door knob. Begin by inserting the new latch. Make sure that the latch is the correct size for the door and that it lines up with the existing hole. Next, match up the holes on the faceplate with the holes on the door. Slide the screws provided with the new door knob through the faceplate and into the holes on the door. It may be easier to use a power drill for this part. Once the screws are in place, attach the new knob to the latch.

Testing the new door knob

After installing the new door knob, it is essential to test it to ensure that it is working correctly. First, ensure that the latch is properly aligned with the strike plate and that the door can close fully. Next, test the lock to ensure that it is functioning correctly. Test the door knob by turning it both ways to verify that it is working correctly.

Adding finishing touches

Once the new door knob is installed and working correctly, you will want to tighten any loose screws that may exist. You can do this with a screwdriver or power drill. Be sure to clean up any debris left behind from the installation process.

Replacing a damaged door knob is a straightforward process that you can do yourself with just a few simple tools. It is essential to fix damaged door knobs promptly as they can be a safety hazard and compromise the security of a property. By following these simple steps, you can have a functional door knob and a secure property once again.

Leave a Reply